Set Parameter

Writes a GenICam parameter value to a camera.

Inputs

Camera (Type: CameraInfo)

Specifies the camera.

Sync (Type: System.Object)

This can be used to establish a temporal order, so that you can specify, what has to occur before the parameter will be written.

Name (Type: String)

The name of the GenICam parameter. These names are determined by the camera vendor.

Value (Type: String)

The value to write to the camera parameter.

Outputs

Sync (Type: System.Object)

This can be used to establish a temporal order, so that you can specify, what has to occur after the parameter has been written.

Comments

The names of the available camera parameters can be found by opening the camera parameters window with the Show Camera Parameters on the Home ribbon bar.

Example

Here is an example that snaps one image, reads the current ExposureTime (20 ms), sets the ExposureTime to 10 ms, takes a second image, sets the ExposureTime back to its original value and takes a third image. The connections of the Sync outputs and inputs establish the temporal order.